ACTIGHOST RAPID GEL | EUROPE ONLY

A HIGHLY VISCOUS, BIODEGRADABLE SOLVENT-BASED SCREEN CLEANER AND ALKALINE ACTIVATOR

Actighost Rapid is a highly viscous alkaline ghost image, ink residue, and emulsion residue remover formulated with biodegradable solvents. It is intended for use following normal stencil removal procedures. Actighost Rapid is virtually odor free and has a high flash point. Because of its high viscosity, Actighost Rapid can be used on coarse mesh and applied with a coating trough. In normal use, Actighost Rapid is sufficiently diluted with water so that it can be flushed harmlessly down the drain and into biological sewage treatment facilities.


INSTRUCTIONS
For Use As A Screen Cleaner
Step 1: STIR AND APPLY ACTIGHOST RAPID

Wear gloves, goggles, and protective clothing. Stir Actighost Rapid briefly, so that the ingredients are homogenized. Pour Actighost Rapid into a stainless steel coating trough and apply it onto the screen mesh from both sides. The mesh should be slightly damp or (preferably) dry.

Step 2: WAIT WHILE ACTIGHOST RAPID REACTS WITH mesh CONTAMINANTS Allow 2 - 5 minutes of dwell time.

Step 3: REMOVE ACTIGHOST RAPID WITH WATER Rinse Actighost Rapid thoroughly from the screen with a gentle spray of water, then wash the mesh with a commercial, high-pressure power spray unit.

For Use As An Activator To Remove Ghost Images Step 1: STIR AND APPLY OXIDIZING AGENT AND ACTIGHOST RAPID Wear gloves, goggles, and protective clothing. Work in a well ventilated area. Apply an oxidizing agent to the screen and allow it to dry. After the required dwell time, apply Actighost Rapid on both sides of the mesh with a stainless steel coating trough.

Step 2: WAIT BRIEFLY Allow a short dwell time.

Step 3: REMOVE OXIDIZING AGENT AND ACTIGHOST RAPID WITH WATER Rinse the oxidizing agent and Actighost Rapid thoroughly from the screen with a gentle spray of water, then wash the mesh with a commercial, high-pressure power spray unit.

CAUTION
Actighost Rapid reacts with frame adhesives, so it should not be used the on bonding areas of rigid frames.

Polyester mesh becomes more vulnerable to damage from Actighost Rapid the finer the mesh that is used, the longer the dwell time, the higher the ambient temperature, or the more the mesh has been used (or damaged). We recommend the testing of Actighost Rapid before its adopted in a shop, and Ulano will not assume responsibility for torn mesh.

Actighost Rapid is corrosive. In case of contact with the eyes, flush them liberally with water and see a doctor. PRODUCT DATA Color: brown to beige Flash point: ? 80º Celsius Density (20º C.): ? 1.17 gm./cubic cm. Storage: 9 months, tightly closed in the original container at 20 - 25º Celsius. After longer storage, especially at low temperatures, the viscosity of Actighost Rapid can increase and it may separate. A brief, vigorous stirring will homogenize the ingredients and lower the viscosity to its original cps.